Project from 2004

Ned Bulken · Nov 22, 2007

Was visiting over on woodcentral and found this in the shop shots section:

That is a box I made for a charity auction to benefit cancer research. Walnut ends with red oak. Watco finish. The ends were cut on the bandsaw, and the center section was cut out with a dado stack iirc.

Stuart Ablett · Nov 22, 2007

Very nice Ned, I expect it was well received too! :thumb:

Toni Ciuraneta · Nov 23, 2007

Lovely! I like the way the lid done :thumb:

Al killian · Nov 24, 2007

I like it, It would make a nice little jelwery box. What did you use to hinge it?

Ned Bulken · Nov 24, 2007

Al killian said:
I like it, It would make a nice little jelwery box. What did you use to hinge it?

iirc I used a simple oak dowel, drilled in from the sides and glued in the dowel on the end pieces only, then sanded them flush before finishing.

This was my first attempt at what was then called a 'knipfer box' over on the WWA.

Vaughn McMillan · Nov 24, 2007

That's a cool-looking box, Ned. I'll bet you're looking forward to when you have the shop done so you can start posting more "project" shots instead of "shop" shots.

Ned Bulken · Nov 24, 2007

Vaughn McMillan said:
That's a cool-looking box, Ned. I'll bet you're looking forward to when you have the shop done so you can start posting more "project" shots instead of "shop" shots.

truer words were ne'er spoken

Search

Project from 2004

Ned Bulken

Member

Stuart Ablett

Member

Toni Ciuraneta

Member

Al killian

Member

Ned Bulken

Member

Vaughn McMillan

Administrator

Ned Bulken

Member