Bandsaw Guide

glenn bradley

Member
Messages
11,516
Location
SoCal
This comes in handy for following curves. Works sort of like a guide pin on the router table. It just gives you a pivot point to help keep things stable through the cut while allowing you to swing your material as required to follow the line. Just a couple of BB ply scraps and a strip of hardboard. Made it to fit the Rockler clamps that come in so handy for such things.
 

Attachments

  • Resaw-guide-1.jpg
    Resaw-guide-1.jpg
    105.5 KB · Views: 133
  • resaw-guide-2.jpg
    resaw-guide-2.jpg
    102.2 KB · Views: 116
Good job Glenn! :thumb:

Do you mind if I copy that one?
I just got my Rockler dowhatsits like that yesterday. :rofl:

DT
 
Copy away. I can't remember where I first saw one (no pun intended); some mag on bandsaws somewhere. I put a 1/4" blade on and played around a bit just now. I could see it coming in handy now and again. I really like the dowhatsits, I don't have to screw things to my Bies or my CMS ;-)
 
Top