larry merlau
Member
- Messages
- 18,741
- Location
- Delton, Michigan
ok i know i am not the only person who likes to have things in somewhat of an ordely manner here so i am going to ask a possibly foolish question.... we all know that you get rust in the supply tank on compressor's i have a large compressor that had been remved from a factory and it need some rework.. i took the water drain off to get the plumbing back into shape and the drain elbow was full of rust.. so my question is should i attempt to clean out the rust from the inside of the tank and if so any suggestions on how.. i can get at the back end and could use a piece of bent conduit to scrape it inside blindly and then suck out the crude with the shope vac,, i know i wouldbget it tall but i could get alot of it.. so whats the verdict just leave it and filter the air coming out real good