Looks like ya got it cleaned up and ready to roll. Nice price on the lathe to.
Bernie Weishapl Member Messages 4,834 Location Goodland, Kansas Jan 1, 2008 #21 Looks like ya got it cleaned up and ready to roll. Nice price on the lathe to.
B Brad Hungler In Memoriam Messages 117 Location Independence Ky Jan 1, 2008 #22 Oil No mask, but I did drive away fast. I added oil into the top reservoir, turned lathe on and oil was coming out of both sides. Bad seals? I did not know what type of oil to use, went with 3in1 penetrating oil. Is this correct oil? Thanks
Oil No mask, but I did drive away fast. I added oil into the top reservoir, turned lathe on and oil was coming out of both sides. Bad seals? I did not know what type of oil to use, went with 3in1 penetrating oil. Is this correct oil? Thanks
Bart Leetch Member Messages 3,206 Location Clinton, Washington on Whidbey Island Jan 1, 2008 #23 The bearings are similar to the bearings in the front of a rear wheel drive car. Pack them with wheel bearing grease. My lathe is the same as yours & thats what I did & it works fine.
The bearings are similar to the bearings in the front of a rear wheel drive car. Pack them with wheel bearing grease. My lathe is the same as yours & thats what I did & it works fine.