NE Maple Bowl

Ben Werner

Member
Messages
100
Location
Hamilton, NY
I'm pretty happy with this one. cracking a tiny bit but not bad. I might end up putting poly on then buffing, or just buffing with the mineral oil it has on now.
6 by 5 1/2 by 3 in high. Critique Please. 3/8 thick... has a tiny bit of curl/quilting.


IMG_1895.jpg


IMG_1894.jpg


IMG_1893.jpg


IMG_1902.jpg
 
Another fine job, young man. :p I think I'd like a bit shorter foot, perhaps with a bead instead of straight sides, but that's just one guy's opinion. Either way, that's a bowl you can be proud of.
 
Nicely done Ben! :clap:

Isn't Maple a dream to turn! :D :thumb:

BTW, on the NE part, on some of the bits where you lost some bark, if you take a hot soldering iron (without any solder on it!) and lightly burn those reddish areas, you will find the blend right in and no one will know you "touched it up"........... or so I've heard..... :rolleyes: ;) :wave:

Cheers!
 
Top