Router Lift for amateurs

Niki Avrahami

In Memoriam
Messages
267
Location
Poland
Good day

In one of the pics of the "Rolling Mortiser", I wrote, "it would be nice to have a router lift"....

So, I made it...very primitive one but, it works...

The advantage of this design is that the crank is out of the table and never interferes with the work and I can change the bit height without stopping the router and that, lets me to "bite" in small increments without stressing the router.

I think that with a little bit of imagination, it can be fitted also to the "normal" cabinet router table but I leave it to you...

Regards
niki

01.jpg02.jpg03.jpg06.jpg05.jpg
 
Thank you so much Stu

I must make it simple...the hardware selection here is very, very poor....not to mention the fact that I don't have the knowledge of "engineering":eek:

Regards
niki
 
Top