Niki Avrahami
In Memoriam
- Messages
- 267
- Location
- Poland
Good day
To test the mortise jig, I made a frame. I cut all the pieces to final dimensions.
I started by cranking the router lift 1~2 turns and make a pass but I ended-up using both hands simultaneously. With the right hand I turned the router lift continuously and with the left hand, moving the jig fore and back so, each mortise took 15~20 seconds.
The jig is not limited only to "edge mortising", by marking the required mortise locations, I can make it anywhere along the workpiece.
Regards
niki
To test the mortise jig, I made a frame. I cut all the pieces to final dimensions.
I started by cranking the router lift 1~2 turns and make a pass but I ended-up using both hands simultaneously. With the right hand I turned the router lift continuously and with the left hand, moving the jig fore and back so, each mortise took 15~20 seconds.
The jig is not limited only to "edge mortising", by marking the required mortise locations, I can make it anywhere along the workpiece.
Regards
niki