Niki Avrahami
In Memoriam
- Messages
- 267
- Location
- Poland
Good day
When I posted the new router table pics, I've shown the way that I made this jig and now, I would like to show the actual usage.
With the method that I used, it took me very short time to cut the fingers because I'm cutting all the 4 boards in one pass and then, just turn the boards and cut again.
The 4 first pics, are showing the jig from different directions.
I used 10mm (3/8") bit.
Regards
niki
When I posted the new router table pics, I've shown the way that I made this jig and now, I would like to show the actual usage.
With the method that I used, it took me very short time to cut the fingers because I'm cutting all the 4 boards in one pass and then, just turn the boards and cut again.
The 4 first pics, are showing the jig from different directions.
I used 10mm (3/8") bit.
Regards
niki