Ed Nelson
Member
- Messages
- 1,486
- Location
- Charlotte, NC
Here is a progress pic of the table I am making for a lady that wanted a workbench to do her painting on. The pieces on the table top are trim pieces for edging the top and they should be ready to attach tomorrow.
The top is melamine. I am trying to figure the best way to attach the top to the base. I was planning to use table top clips, but I am concerned about the screws holding in the particle board core. I do need this to be knock down capable. Any thoughts on this are appreciated!
The top is melamine. I am trying to figure the best way to attach the top to the base. I was planning to use table top clips, but I am concerned about the screws holding in the particle board core. I do need this to be knock down capable. Any thoughts on this are appreciated!