Ken Fitzgerald
Member
- Messages
- 2,322
A Jet VS Mini....adding a PM 3520B early this fall.
Now why would you want to go do a thing like that, Ken? You realize there are a number of us who fell into the abyss while watching you get thrown into it by others, so if you get a 3520, then the rest of us are gonna have to get something on par with that. I dunno if I can afford it by early fall....adding a PM 3520B early this fall.
General international 1642
My first post to
Now why would you want to go do a thing like that, Ken? You realize there are a number of us who fell into the abyss while watching you get thrown into it by others, so if you get a 3520, then the rest of us are gonna have to get something on par with that. I dunno if I can afford it by early fall.
(Unfortunately, it looks like it'll cost me more than the lathe just to get our house power upgraded to the point where I could run a lathe like that.)
Thats way to clen, don'tcha ever use it ?
It looks a little different now, That was taken right after I got the lathe set up. I even put some OSB on the floor to help with the cleanup.Thats way to clen, don'tcha ever use it ?
Since this thread is alive again and I now have my new lathe, here is a pic of the Jet 1442
It's clean and unused. You should be ashamed of yerself.
It WAS clean and unused, I'll bet that floor will NEVER be that clean again, right Jim
My shop's carpeted, but I never get accused of keeping the place too clean. Nice on the feet, but it collects too much dust. (The garage was carpeted when we bought the place.) I may break down and pull it all out one of these days if I ever get motivated enough to completely empty the place.But the whole room was so clean and neat. And it was CARPETED. For a woodturner, there are laws against such things, I'm sure.