Mike Rathe
Member
- Messages
- 22
- Location
- Columbia, SC
Ok so I have been thinking about getting the Oneway Wolverine system, probably the basic platform and then the vari-grind. I figured if I bought the basic platform for $80 and the vari-grind jig for $47, that comes out to $127, then Hartville gives 20% for Club members, so it comes out to about the same as buying the PSI system, only without the Skew sharpening jig, which I can do without for now.
Question 1 - I have a Shopfox 6" slow speed grinder http://www.woodstockint.com/products/m1107/
will the Wolverine fit this, I think I might just have to make a little platform for my grinder?
Question 2 - I know there are two Vari-Grind tools, one that is a little bigger, which one should I get, and common sense leads me to say get the bigger one because it can handle smaller tools as well, but you know what they say about common sense...its not to common.
Question 3 - I was watching a video by Joe Ruminski from Asheville, NC and he used a little template to set the length of the V-Arm on the jig to get quick repeatable results with the Vari-Grind, do any of you guys know where I can get templates for this or can tell me how to do this?
Thanks a lot!
Mike
Question 1 - I have a Shopfox 6" slow speed grinder http://www.woodstockint.com/products/m1107/
will the Wolverine fit this, I think I might just have to make a little platform for my grinder?
Question 2 - I know there are two Vari-Grind tools, one that is a little bigger, which one should I get, and common sense leads me to say get the bigger one because it can handle smaller tools as well, but you know what they say about common sense...its not to common.
Question 3 - I was watching a video by Joe Ruminski from Asheville, NC and he used a little template to set the length of the V-Arm on the jig to get quick repeatable results with the Vari-Grind, do any of you guys know where I can get templates for this or can tell me how to do this?
Thanks a lot!
Mike