Results 1 to 3 of 3

Thread: In the shop

  1. #1
    Join Date
    Nov 2006
    Location
    Oak Harbor Washington on Whidbey Island
    Posts
    3,134

    In the shop

    I got started on the frame & panel doors for my Dad's laundry cabinet for above his washer & dryer. You see the rails & styles stacked on the bench along with the rest of the messy shop. These are my first of this style doors.
    Attached Thumbnails Attached Thumbnails Cope & Stick door frames 001.jpg   Cope & Stick door frames 002.jpg   Cope & Stick door frames 003.jpg   Cope & Stick door frames 004.jpg  
    "Forget the flat stuff slap something on the spinny thing and lets go, we're burning daylight" Bart Leetch
    "If it ain't round you may be a knuckle dragger""Turners drag their nuckles too, they just do it at a higher RPM"Bart

  2. #2
    Join Date
    Nov 2006
    Location
    Tokiwadai, Japan
    Posts
    2,882
    Ah, looks familiar, Bart. I'm finishing up a raised panel wainscoting wall panel for our powder room. I used the Freud router bit set. Did you use a special shaper bit set, or one for a router mounted in your shaper?

    BTW, nice shaper..

    Attachment 20011

    Look forward to watching your progress.
    Last edited by Greg Cook; 09-13-2009 at 03:47 AM.

  3. #3
    Join Date
    Nov 2006
    Location
    Oak Harbor Washington on Whidbey Island
    Posts
    3,134
    Greg

    That is my Dad's Shaper & in this shot you'll see the plywood box that has the shaper cutters that he used to the right of the door frames..
    Attached Thumbnails Attached Thumbnails Cope & Stick door frames 001.jpg  
    "Forget the flat stuff slap something on the spinny thing and lets go, we're burning daylight" Bart Leetch
    "If it ain't round you may be a knuckle dragger""Turners drag their nuckles too, they just do it at a higher RPM"Bart

Similar Threads

  1. Shop sweet shop-UPDATE
    By Ken Cook in forum Off Topic Discussion
    Replies: 12
    Last Post: 09-24-2013, 07:31 PM
  2. great day for shop today, horrible day for shop today
    By allen levine in forum Off Topic Discussion
    Replies: 13
    Last Post: 04-07-2013, 03:51 PM
  3. Shop Renovation: Ned's Shop gets a facelift: Relocation plans
    By Ned Bulken in forum Carpentry and Construction
    Replies: 92
    Last Post: 10-31-2012, 12:06 AM
  4. Is the shop a dangerous place for our shop pets?
    By Tom Baugues in forum General Woodworking Q&A
    Replies: 18
    Last Post: 07-30-2012, 08:41 PM
  5. Shop - Organizing the clamps, finally! + Shop Tour
    By Rob Damon in forum Shop Tours
    Replies: 35
    Last Post: 02-09-2011, 04:16 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •