Kevin Vernon
Member
- Messages
- 112
- Location
- 39.92*N x 86.01*W
First off - I have a fixed base, in a table - came as a combo, this particular Ryobi:
Actually, the Ryobi combo I have is a bit older than this one shown, it has a slightly different guard/dust chute arrangement, and the router that came with it has only a fixed base, not a plunge like this one in the photo.
I have already determined I'd like a bigger table for it, and a lift - any clue as to which router lift might work best with this, or should I ditch it & get something else?
2nd: I also have a plunge, for hand-held work. It is a POS H.F. unit...
and it is DEFINITELY going away, my question being, what are your thoughts on relpacing it with THIS:
Hitachi KM12VC
I'm open to suggestion & fishing for information & input here, gang....love to hear what y'all think.
-Kevin in Indy
Actually, the Ryobi combo I have is a bit older than this one shown, it has a slightly different guard/dust chute arrangement, and the router that came with it has only a fixed base, not a plunge like this one in the photo.
I have already determined I'd like a bigger table for it, and a lift - any clue as to which router lift might work best with this, or should I ditch it & get something else?
2nd: I also have a plunge, for hand-held work. It is a POS H.F. unit...
and it is DEFINITELY going away, my question being, what are your thoughts on relpacing it with THIS:
Hitachi KM12VC
I'm open to suggestion & fishing for information & input here, gang....love to hear what y'all think.
-Kevin in Indy