Keith Starosta
Member
- Messages
- 161
- Location
- Fredericksburg, VA
I was hoping to get some information about what would be the best blade to use when milling out wide (4+ inches) cove molding on the table saw? I currently have a Forrest WWII and the Freud LM72R Heavy Duty Rip blade. For this operation, would it be best to use a blade dedicated to ripping, or crosscutting, or is a combination blade (like the WWII) OK, as well?
Thanks very much for any help!!
- Keith
Thanks very much for any help!!
- Keith