Results 1 to 3 of 3

Thread: negative pressure room

  1. #1
    Join Date
    Nov 2006
    Location
    Delton, Michigan
    Posts
    17,477

    negative pressure room

    well i tried my idea out in the finish room which i had gathered from a forum tip but i got the exhaust part wrong.... i have more air coming in that can get out.. i have a 3 speed furnace fan blowing in on the slowest setting but i need to get that bad air back out down low.. i think i can get that with another furnace fan but the little helper fan i had was'nt enough.. i close the door and it goes out under the door because it can get out elsewhere i can help it out alot if i open the window but that will cause the fumes to rise again and want them to stay low if can out off my smeller any ideas from the engineers out there...
    If in Doubt, Build it Stout!
    One hand washes the other!
    Don't put off today till tomorrow!

  2. #2
    Join Date
    Oct 2006
    Location
    The Heart of Dixie
    Posts
    4,268
    Add vents?
    God grant me the senility to forget the people I never liked anyway,
    the good fortune to run into the ones I do,
    and the eyesight to tell the difference.


    Kudzu Craft Lightweight Skin on frame Kayaks.
    Custom built boats and Kits

  3. #3
    Join Date
    Nov 2006
    Location
    Delton, Michigan
    Posts
    17,477

    VENTS

    any suggestions on how to vent without having the winter air blow in???? that was why i thought i could blow it out therefore having less winter access...saw what marty has but that thing will suck me out
    If in Doubt, Build it Stout!
    One hand washes the other!
    Don't put off today till tomorrow!

Similar Threads

  1. Negative rake scrapers?
    By Roger Tulk in forum Turning Tool Questions and Show & Tell
    Replies: 3
    Last Post: 08-02-2015, 11:15 AM
  2. Negative Rake Scraper
    By Bernie Weishapl in forum Turning Tool Questions and Show & Tell
    Replies: 13
    Last Post: 11-11-2011, 02:23 PM
  3. Negative Rake Scraper
    By Bernie Weishapl in forum Turning Tool Questions and Show & Tell
    Replies: 18
    Last Post: 01-09-2009, 02:00 AM
  4. about negative rake blades
    By Frank Fusco in forum General Woodworking Q&A
    Replies: 9
    Last Post: 06-25-2007, 12:43 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •