Mark Pruitt
Member
- Messages
- 49
- Location
- Leeds, AL
I've "lurked" here at FW for a long time but not been active at posting as of yet. I've run into a situation that I'd like to hear from someone who has experience working with Minwax Wood Hardener.
I've just started using the product to reinforce punky areas in a couple of pieces that I've turned. Initially, I applied the MWH with the piece still on the lathe (not running, of course), let it set up for a few hours, came back and finished turning/sanding the piece. When I applied the first coat of BLO, the wood completely absorbed some of the BLO notwithstanding the fact that I had saturated it with MWH.
So here is my question. I am tempted to re-apply MWH to the piece (and allow it to dry overnight) prior to applying another coat of BLO. This seems like it should not be problematic, but if anyone here has had a negative experience doing this (or positive for that matter) I would appreciate hearing about it.
I've just started using the product to reinforce punky areas in a couple of pieces that I've turned. Initially, I applied the MWH with the piece still on the lathe (not running, of course), let it set up for a few hours, came back and finished turning/sanding the piece. When I applied the first coat of BLO, the wood completely absorbed some of the BLO notwithstanding the fact that I had saturated it with MWH.
So here is my question. I am tempted to re-apply MWH to the piece (and allow it to dry overnight) prior to applying another coat of BLO. This seems like it should not be problematic, but if anyone here has had a negative experience doing this (or positive for that matter) I would appreciate hearing about it.