larry merlau
Member
- Messages
- 18,741
- Location
- Delton, Michigan
tonight i was in the shop and had a round over to do so i grabbed a new 1/2" round over bit made by "infinity tools" and stuck it in and tightened it up.. well i thought i did.. anyway i proceded to do my parts and got them done but as it was stopping i thought i saw a quiver in it.. it stopped, i turned of the router and proceded to take it out. reached for the wrench to loosen it and i could pull it out by hand with out to much trouble so i retightneded it or tried to but it wouldnt tighten down.. put in a whiteside and it wouldnt fit went and got he calipers and found out the shaft on the infifnity was .489 and the whiteside was .500 this bit from infinty was given to me threw a raffle but it may have been a second dont know.. but i do know the hitachi collet dint like it.. so its something that we should be aware of next time.. i got lucky