I recently bought a new MM16 and went through the setup process. I set the fence parallel to the blade. I cut a piece of wood today that is about 12" wide. As I got about half-way through the cut the wood was pulling away from the fence on the out-feed side. I finished the cut and pushed the fence back over to the blade and it was where it should be. I scratched my head and looked for the problem. I noticed the bar the fence rides on is not parallel to the table! It splays out (smaller at the right, larger at the left). I looked at the attachment parts and I don't see any ability to adjust this bar. I put a straight edge against the bar and it seems to be dead on. Anyone have any ideas on a fix for this problem?