Sean Wright
Member
- Messages
- 902
- Location
- WNY, Buffalo Area
Before I do it, I thought I would throw this out for some feedback.
I am in the process of making 3 raised panel doors for a cabinet. I am planning on putting a 45 deg. chamfer on the outer edges of the doors.
Would it make a difference if I used the table saw or router table to put this chamfer on?
I don't think it would, but I know there are alot more people out there with alot more experience than me.
Thanks !
I am in the process of making 3 raised panel doors for a cabinet. I am planning on putting a 45 deg. chamfer on the outer edges of the doors.
Would it make a difference if I used the table saw or router table to put this chamfer on?
I don't think it would, but I know there are alot more people out there with alot more experience than me.
Thanks !