My XYZ For the Swap

Charles Hans

Member
Messages
1,412
Location
Independence, Kentucky
Well, I dug into my scrap buckets and found some suitable scrap to get me started,So here goes.
P1040879.jpgP1040878.jpg

Pulled out some walnut pieces and started cutting them down. Then as luck would have it the table saw crapped out for some strange reason.
After troubleshooting the motor There was no problem there, so I went to the switch and Yep, It was toast inside , good old Chiwaneese products. So I wired around the switch and got the old beast going again. Needless to say I wasn't in the mood for much more today so tomorrow I will give it another go..
 
Wow you raised the bar some for this swap. Scrap eh, need to come pay your scrap bin a visit. lol
Nice work Charles someone is going to be mighty happy.

Sent from my SGH-I337M using Tapatalk
 
Top