Ned Bulken
Member
- Messages
- 5,529
- Location
- Lakeport NY and/or the nearest hotel
I didn't measure it, but I'd guess it is about 6.5" across and 4-5" tall. Bagged with shavings. revisit/return in a couple of months.
Looking good, Ned. One suggestion I'd make is to use the roughing-out time to practice your finishing cuts. For one, it's easier to make the different types of cuts on green wood, and by leaving a smoother rough-out, you'll make the real finish turning easier. Things like the ridges in the bottom of this bowl are easier to handle now, when the wood is green, compared to later when it's dry.
Thanks y'all!
Vaughn, I make 'every' cut as a practice cut. I hear you though. This bowl was 'tough' for a cherry bowl I had a hard time with parts of it, there was a resonance zone where every cut was 'hard' due to a grain change. It didn't matter what gouge or angle of attack I took, it vibrated and fought the gouge with every cut. I see that bump at the bottom of the bowl, as soon as I get some coffee in me, I'll see what I can do to eliminate that bump. I'm trying with every bowl to make them as smooth as I can from the get-go. I'm learning that I need to sharpen more often of course, so I start each session with a quick trip on the wheel, then as needed following that.
Good deal.
Generally, the vibration is the result of dull tools and/or trying to take too big of a cut. If it's still vibrating with light cuts after a trip to the grinder, try changing the speed of the lathe. Often, a slower or faster speed will side-step the resonance issue. I've also had vibration problems sometimes when I was using smaller, lighter tools. (This is particularly true with scrapers. I always had issues with scrapers until I started using big fat honkin' heavy ones.) Speaking of scrapers, that would be my go-to tool for removing the ridges at the bottom of that bowl.
In addition to all the critique and suggestions I've been sending your way, I do want to mention that your forms are looking good. You're progressing nicely...most of us have been down the same roads. Just yesterday I was packing up some of my earlier turned pieces, and I was kind of shocked to see how heavy and clunky some of them were. One bowl in particular had walls that were only about 1/4" thick at the rim, but they got thicker as they went down, eventually ending with a bottom that's probably 1" or more thick. I handed it to my wife and she was shocked to see how heavy it felt.