Mark Pruitt
Member
- Messages
- 49
- Location
- Leeds, AL
Here are a couple of HFs I recently completed out of some oak I had lying around. Both finished with Arm-R-Seal and Beall buffed.
This one is about 7.5" dia. with a Bloodwood collar:
And this one is about 9" dia. with Santos Rosewood collar:
The last coats of Arm-R-Seal finish were applied off the lathe, and the stuff was such a PITA to work with that in the future I am probably going to restrict my use of it to applying while on the lathe.
Comments welcome!
This one is about 7.5" dia. with a Bloodwood collar:
And this one is about 9" dia. with Santos Rosewood collar:
The last coats of Arm-R-Seal finish were applied off the lathe, and the stuff was such a PITA to work with that in the future I am probably going to restrict my use of it to applying while on the lathe.
Comments welcome!