CarveWright Question

Sean Wright

Member
Messages
902
Location
WNY, Buffalo Area
Does anyone have or know anything about the CarveWright systems?

I was asked today if it was possible to install the software that it comes with, on more than one PC that the same person owns. I don't see why not..... but you never know when it comes to software.

Any help would be appreciated!
 
Sean, I am not a member but have "lurked" over at CW as it always interested me, but until I get a stand alone, specific shop built, it would be a waste of my time and money. They might be able to answer your question at:

http://forum.carvewright.com//

I have also been lurking and doing a lot of reading about the torchmate system as I can utilize a plasma cutting head or a router and do three dimensional routing. :dunno:

Hope the address helps.
 
Does anyone have or know anything about the CarveWright systems?

I was asked today if it was possible to install the software that it comes with, on more than one PC that the same person owns. I don't see why not..... but you never know when it comes to software.

Any help would be appreciated!

Sean,

As far as I know the software can be loaded on two computers only.
 
Top