Dennis Thompson
Member
- Messages
- 75
- Location
- New Jersey
I have no room in my shop for anything but a benchtop jointer. Can anyone suggest which one is the best?
Thanks
Dennis
Thanks
Dennis
I have the Delta that Jason didn't care for. It has been a nice little unit within a benchtop jointer's abilities. I love the variable speed and it is light enough to lift to wherever you plan to use it and heavy enough to stay there resting on a sanding / routing mat; no clamps required.
How are your aluminum beds holding up?
I keep the beds and the fence waxed and have no wear problems at all. This was a concern of mune as well. I had some issues out of the box with the cut and at first blamed my novice technique or the tool and almost fell into buyer's remorse. Then thanks to the forum, I gained a little knowledge and checked a few things. After shimming the front right corner of one of the beds ever so slightly, my problem was solved. Either that or I just suddenly got better (yeah, right).
Here's the one i had: http://www.sears.com/shc/s/p_10153_12605_00921788000P