- Messages
- 11,636
- Location
- Constantine, MI
I've been talking here for a few months about upgrading my 6" jointer to an 8". I came very close to pulling the trigger on the Griz 4090X a few times but just could not do it. Sometime procrastinating is a good thing!
I found this on Craigs list. A local cabinet shop was shutting down and liquidating. Not a bad deal at $750! He also had a 37" wide belt sander. Sorry Larry, just not enough room in my little shop.
The tables need a little work to polish them up and remove some stains. I tried some 1000 and 1500 grit paper with a block and it works well but very slow. Any suggestions from our pro-restorers out there?
I found this on Craigs list. A local cabinet shop was shutting down and liquidating. Not a bad deal at $750! He also had a 37" wide belt sander. Sorry Larry, just not enough room in my little shop.
The tables need a little work to polish them up and remove some stains. I tried some 1000 and 1500 grit paper with a block and it works well but very slow. Any suggestions from our pro-restorers out there?
Last edited: