Stuart Ablett
Member
- Messages
- 15,917
- Location
- Tokyo Japan
I recently moved some of the stuff around by my computer and I have this area that is kind of open, I need to make the best use of my space as it is so small.
Just a quick and dirty little pull out drawer unit.
The bottoms of the draws will be 5.5 mm plywood, these will act as the runners, so I cut all my slots in the sides of the box in one go.
The two sides of my box
The back and some fronts to go
Basically that's it done, just some finger holes and then install it
Installed. The drawers are too high to look into, but with the bottoms acting as the runners, they come out easily and can be set on the bend to dig through.
Not a lot of everyday stuff will live in these drawers, but it is good to have the storage just the same.
Total start to finish took less than an hour.
Thanks
Just a quick and dirty little pull out drawer unit.
The bottoms of the draws will be 5.5 mm plywood, these will act as the runners, so I cut all my slots in the sides of the box in one go.
The two sides of my box
The back and some fronts to go
Basically that's it done, just some finger holes and then install it
Installed. The drawers are too high to look into, but with the bottoms acting as the runners, they come out easily and can be set on the bend to dig through.
Not a lot of everyday stuff will live in these drawers, but it is good to have the storage just the same.
Total start to finish took less than an hour.
Thanks
Last edited: