Dave Richards
Member
- Messages
- 2,930
- Location
- SE Minnesota
How about a turned octagonal column for a table pedestal?
Bill's zooming ahead so perhaps he'd like to give that a go.
For the rest of you, let's build off that little box from before. This time it's an inset drawer with half-blind dovetails on the front, through dovetails in the back and a bottom with the edges beveled to fit into grooves in the front and sides.
Dimensions are at your discretion but it should be of a usable size. The pull is extra credit and the screw is extra-extra credit.
Bill's zooming ahead so perhaps he'd like to give that a go.
For the rest of you, let's build off that little box from before. This time it's an inset drawer with half-blind dovetails on the front, through dovetails in the back and a bottom with the edges beveled to fit into grooves in the front and sides.
Dimensions are at your discretion but it should be of a usable size. The pull is extra credit and the screw is extra-extra credit.