Yann Arbour
Member
- Messages
- 113
- Location
- Field, Ontario, Canada
Greeting y'all
I'm planning to make some shelves in my son's wardrobe using 97"x12"x5/8" melamine and my SCMS.
My question is does anyone have experience cutting dadoes in this stuff using only a thin kerf 100t blade on an SCMS? What was the process used? What was the end result? Would you do it again if you had to? Why or why not?
Thanks,
Yann
I'm planning to make some shelves in my son's wardrobe using 97"x12"x5/8" melamine and my SCMS.
My question is does anyone have experience cutting dadoes in this stuff using only a thin kerf 100t blade on an SCMS? What was the process used? What was the end result? Would you do it again if you had to? Why or why not?
Thanks,
Yann