Recent content by Greg Heichel

Fantastic!! Thank you very much for the advice!!

Hello all, I just invested in a jointer and planer. As I was practicing making tabletops I noticed that when I joint the edge and then run it through the table saw to make the other side parallel, circular saw marks were left which seems to not allow the joint to seat tightly to one another...

Thank you Jim. Good to be aboard. Any thoughts on if I can get an angle now that the top and bottom are straight or is this a learning moment and the leg gets scrapped?

i am a beginner woodworker and working on a round dining room table. I am making it out of pine first as a prototype before investing in better wood. The legs are angled with a through mortise and tenon. First time I’ve done this and ran into a snag when trying to dry fit it. The leg won‘t...