Dave Richards
Member
- Messages
- 2,927
- Location
- SE Minnesota
Stupid simple project but it needed to be done. I finally got tired of our selection of cutting boards. They are either too big or too small. This is roughly 12 x 16 inches. Nothing fancy but it'll do the job. Started with a piece of maple about 6 in. wide planed to 7/8 in. thick. Ripped an edge off on the tablesaw, cut it in half and glued the pieces together. Seam is tight. (It pays to tune up the tablesaw) A bit of edge round, sanding, and some butcher block oil and done.
I wonder if plans for this would sell.
I wonder if plans for this would sell.