- Messages
- 7,986
- Location
- falcon heights, minnesota
while i was milling the parts for the candy machines, my sister called, and asked if i could make a name sign for her husband's grandson, and could it be ready for this saturday. i said that i will give it a try, as most of the week will be taken up by work, and pop is getting the garage ready for the birthday party. well, today i picked out the board for the project (cost me all of $1). sanded to 220, and edge planed, and ripped to width. then cut the board into 2 blanks, and commenced to cutting the signs. got them both cut today, just need to trim off the edges, a little remedial sanding, and give them a blo finish.
Attachments
-
001 blank sanded and edge planed.JPG145.8 KB · Views: 13
-
002 blanks cut.JPG145.4 KB · Views: 13
-
003 first sign ready for milling.JPG98 KB · Views: 13
-
004 first one done and ready for sanding.JPG115.7 KB · Views: 16
-
005 second one started.JPG125.3 KB · Views: 17
-
006 both done and ready for finishing.JPG119.3 KB · Views: 22