- Messages
- 11,427
1) Decimals are important....
while running a part today I noticed the machine running quit a bit faster than I was planning on running the part. I looked up at my feed rate on the display and it said 5000 FPM.. Good thing I set the max at 500 so I looked at my set up sheet and somehow when I put in the fees rate into the program when setting up that operation I missed a decimal point.... Oh well no harm done...
while running a part today I noticed the machine running quit a bit faster than I was planning on running the part. I looked up at my feed rate on the display and it said 5000 FPM.. Good thing I set the max at 500 so I looked at my set up sheet and somehow when I put in the fees rate into the program when setting up that operation I missed a decimal point.... Oh well no harm done...