Door drying rack.

John,

What did you use for the supports? Those look potentially handy..
It's 1/4" cold rolled steel rod. I buy 20' pieces for less than $5! I just drilled holes and tapped them in. I had already cut them when I realized that it would have been easier to cut them to 40" and drill all the way through. LOL

Then I got a 100' roll of 1/4" heat shrink tubing and some caps. It should keep the doors from getting scratched or marked up with the raw steel. Again, I wish I had gotten 3/16 tubing, but the 1/4 works fine.
 
Last edited:
Top