Gayl Beals
Member
- Messages
- 259
- Location
- Muskegon,Mi.
I revamp the jig and added two spacer so can double cut if I need to, and it works quite well .
This thread goes into some of the details how I've done them in the past. The methods can vary a bit, but the principle is still the same.I never understood how those are made. Great job!
Titebond llOut of curiosity did you use epoxy or yellow glue?
I have always like your mills , I will put that on my list to make,with a Celtic knot .I'm impressed with your Celtic knot in the rolling pin... I tried one in a pepper mill... didn't quite reach the level you did... gave up after 2 cuts...
View attachment 114338 View attachment 114339 View attachment 114340