- Messages
- 11,427
Well I think I am finally getting the hang of this, after playing around with the retraction and putting on a fresh roll of filament this is the results, I still need to do a little bit of clean up but all in all not bad.
Finally gett'n the hang of these lithophanes
- Thread starter Don Baer
- Start date
- Messages
- 16,585
- Location
- Reno NV
Looks great!
- Messages
- 20,168
- Location
- Springfield, Missouri
Nice work Don! 
David Johnson
Member
- Messages
- 3,273
- Location
- Carthage,Mo
That's very nice. Almost heirloom looking picture.
David
David
- Messages
- 20,168
- Location
- Springfield, Missouri
One big tip for quality, keep your filament bagged up with desiccant bags to keep any moisture out of the roll, even in your environment. I keep 2 gallon bags on hand and put the roll away when finished with a job. The moisture in the roll expands when printing and causes a lot of the little goobers.
- Messages
- 11,427
I have them in air tight container and some have desiccant in them but not all I need to get more. During monsoon season it not a dry heat....lol
- Messages
- 16,585
- Location
- Reno NV
I've got a jerky dehyrdrator I'll put stuff in from time to time if I have problems printing. Oddly enough, I have more trouble printing in the summer here due to the swamp cooler than I do in the winter.
- Messages
- 11,427
playing around with the settings a little, this one I am sending to my sister after I clean it up a bit. She is in an assisted living facility in Mo. Its her 2 grand sons and they live in Long Island and she doesn't get to see them much.
