- Messages
- 11,639
- Location
- Constantine, MI
It’s been a few months since John posted his thread about his new adjustable height workbench. I read all the posts and even tried John’s patience with several PM’s. I vacillated between the HF lift and this bench and even between the 52” and 46” version or drawers and no drawers. I nearly pulled the trigger three times, hesitated, and they were sold out in hours.
I finally made up my mind and placed the order. I went with the 46” as it will be easier to move around the shop and I have a 30 x 60 top I was going to use on a homemade bench that I can attach when extra room is needed. What pushed me over the edge was the ability to adjust the height to match any of my large tool table heights.
I finally made up my mind and placed the order. I went with the 46” as it will be easier to move around the shop and I have a 30 x 60 top I was going to use on a homemade bench that I can attach when extra room is needed. What pushed me over the edge was the ability to adjust the height to match any of my large tool table heights.