Laser upgrade to a camera

Leo Voisine

Member
Messages
5,922
Location
East Freeetown, Massachusetts
I just upgraded my Laser machine with a Lightburn camera.

Not really sure how or when I will use it. Well yes I do know. I know that I really could have used it on a past job that I screwed up because of trying to locate a picture in a pocket. The camera setup will REALLY be instrumental in dialing in locations like that where a reference point is hard to define.
 
I've used mine quite a bit. IT's accuracy does depend quite a lot on the calibration, which can be a little finicky. It also really depends a lot of the z height of the top of the material. The more consistent you can position the top of the material at your focal distance, the more accurate it will be.
 
Top