Menu
What's new

Need your help with repairing my Delta Table saw.

D

David Trompower

Member
Messages
7
I hope I am posting this in the correct area, moderator, please move this posting to the correct forum, if necessary.I am repairing my table saw I inherited. Now I need to build what ever it is that the 'splitter' attaches to . I have the splitter and a mounting bracket. I don't have any clue what the bracket attaches to but i know it mounts some where and some how, near the motor.
I hoping for pictures or drawings that clearly show how the splitter attaches to the frame of the table saw, and firmly, and securely holds it in place behind the blade. I am assuming the mounting method some how allows for quick removal for dadoing and re- installation.

My saw is a Delta 10 inch model 34-670
 
Darren Wright said:
Looks like you may be able to get any missing parts from here, I clicked on most of them and they showed as available...
http://www.ereplacementparts.com/delta-34670-type-inch-table-saw-parts-c-3275_3334_7069.html
Click to expand...

Thanks Glenn and Darren! However upon closer examination and measuring, I don't think this is my table saw.. I found a serial number for the saw. it is Delta 91H51264 and cat. No# 34-444 i don't know if it is a type 1 or 2 .
But I think the spreader and brackets i need looks like this: http://www.ereplacementparts.com/bracket-p-192901.html and http://www.ereplacementparts.com/splitter-wbushing-p-84421.html.

But I don't know how it attaches the table saw frame, back by the motor. and i would like measurements for these items so I can make my own.
Any help with pictures and measurements any one please?
Thanks
 
David Trompower said:
Thanks Glenn and Darren! However upon closer examination and measuring, I don't think this is my table saw.. I found a serial number for the saw. it is Delta 91H51264 and cat. No# 34-444 i don't know if it is a type 1 or 2 .
But I think the spreader and brackets i need looks like this: http://www.ereplacementparts.com/bracket-p-192901.html and http://www.ereplacementparts.com/splitter-wbushing-p-84421.html.

But I don't know how it attaches the table saw frame, back by the motor. and i would like measurements for these items so I can make my own.
Any help with pictures and measurements any one please?
Thanks
Click to expand...

Can you take a picture of the back of the saw for us, specifically where the bracket would connect at the rear. There are actually 4 types of that model number. After looking at it the type 3 looks like the one I have, can check this weekend to verify.
 
You must log in or register to reply here.
Top