project x for the swap

[Rob Keeble]

Dan i dont play cribbage but i can see that doing really well at your craft sales.
You sure getting your monies worth out of that Shapeoko cnc.
Well done man.

Dan apart from your 3d cut experiences can you run something like this in batches and unsupervised or do you have to be around all the time?

Sent from my SGH-I337M using Tapatalk

 

[Jim C Bradley]

Gee, I sure wish I could see the pics. All I get are a couple wide, horizontal, black bands with a white band in the middle. The middle white band has a black box with the little, multi-fingered, circle going round and round (just like my head).

Enjoy,
JimB

 

[Dan Noren]

rob, i can set up for batches, one at a time though. the bass takes about 4 hours, the rest take about an hour each. also, the item is going out in tomorrow's mail, should be showing up somewhere in a couple three days....

 

[Ryan Mooney]

Well looky what was waiting on my doorstep! A fantastic bass cribbage board in what looks to be walnut unless I'm missing my guess.



Now I have to remember how to play cribbage again! I used to play it all the time with my uncle when visiting my grandparents over the summer but haven't much since then for some reason.

The back side of the board is a real pretty piece of wood as well.

 

[Leo Voisine]

You would just cry if you knew just how much beautiful wood went into my woodstove over the years.

Much less goes in there now.

 

[Brent Dowell]

Nice! Good to see some folks are receiving their swaps!