Dominic Greco
Member
- Messages
- 149
- Location
- Bucks County PA
Hi gang,
While cleaning up the shop over the past weekend I came across this sheet of UHMW (or is it UHMV?...whatever!) that I purchased from PeachTree USA several years back. It was meant as a face for a tablesaw jig that never got made. It fell behind some boards and was forgotten until this weekend.
I took one look at it and then my shoot board and decided it was time for a retrofit. I cut it to size and countersunk (8) holes for brass screws.
I had a chance to use this while I was making some tool hangers for my tool cabinet. It worked even better than I had hoped. My LN#9 glides right over it.
Thanks for viewing!
See ya around,
Dominic
While cleaning up the shop over the past weekend I came across this sheet of UHMW (or is it UHMV?...whatever!) that I purchased from PeachTree USA several years back. It was meant as a face for a tablesaw jig that never got made. It fell behind some boards and was forgotten until this weekend.
I took one look at it and then my shoot board and decided it was time for a retrofit. I cut it to size and countersunk (8) holes for brass screws.
I had a chance to use this while I was making some tool hangers for my tool cabinet. It worked even better than I had hoped. My LN#9 glides right over it.
Thanks for viewing!
See ya around,
Dominic