glenn bradley
Member
- Messages
- 11,558
- Location
- SoCal
There are a lot of pegs in the night stands I'm working on. I had to stop and touch up the motise chisel so I took a few shots.
A couple cones and a diamond plate touch up the chisel in just a few moments:
Whack this thing to mark your territory:
Clean out with a 1/4" chisel to about 1/4" deep:
1/4" dowel goes through the tenon. 5/16" ebony plug goes in the square hole.
A couple cones and a diamond plate touch up the chisel in just a few moments:
Whack this thing to mark your territory:
Clean out with a 1/4" chisel to about 1/4" deep:
1/4" dowel goes through the tenon. 5/16" ebony plug goes in the square hole.