- Messages
- 36,121
- Location
- ABQ NM
Here's proof that not everyone on YouTube knows what they're doing. This guy shows several classic examples of what not to do when turning.
http://www.youtube.com/watch?v=GuZDaF48oD0
Aside from the fact that he's running at stupidly high speeds for roughing, he doesn't seem to know much about how to use his "straightener out" tool or his "rounder" tool. At about 5:20 into the video, he's using the wrong side of the sandpaper. He could also use a few tips on parting something off at the end. I'd be willing to be he's not wearing any face protection (based on the way his voice sounds). This guy's a real piece of work.
On the plus side, he has a good chance of pulling a Darwin and removing himself from the gene pool.
And if by chance, "Dunkin717" is a member here, sorry for being harsh, but dude, get some lessons. And quit posting dangerous techniques on the Intarweb.
http://www.youtube.com/watch?v=GuZDaF48oD0
Aside from the fact that he's running at stupidly high speeds for roughing, he doesn't seem to know much about how to use his "straightener out" tool or his "rounder" tool. At about 5:20 into the video, he's using the wrong side of the sandpaper. He could also use a few tips on parting something off at the end. I'd be willing to be he's not wearing any face protection (based on the way his voice sounds). This guy's a real piece of work.
On the plus side, he has a good chance of pulling a Darwin and removing himself from the gene pool.
And if by chance, "Dunkin717" is a member here, sorry for being harsh, but dude, get some lessons. And quit posting dangerous techniques on the Intarweb.