- Messages
- 11,607
- Location
- Constantine, MI
I place this before the learned and experienced minds of the family. I need your guidance.
I'm working on the chancel furniture and part of it requires a plywood platform edged in oak 2.5" wide. Although I really took my time with these miters, I still have a few gaps that I have to fill. I've not had much success with some of the commercial fillers, so I was wondering what you used. I've tried the plastic wood, don't like it. The Elmer's is a bit better, but still not great. I have some Timbermate, works OK. Any suggestions? Any brands that work well? Mix your own?
Here's the joints. The gaps are small (and I have a little tear out in the plywood to deal with too. The magnification makes them look larger than life. Remember that the width of the border is 2.5"
I'm working on the chancel furniture and part of it requires a plywood platform edged in oak 2.5" wide. Although I really took my time with these miters, I still have a few gaps that I have to fill. I've not had much success with some of the commercial fillers, so I was wondering what you used. I've tried the plastic wood, don't like it. The Elmer's is a bit better, but still not great. I have some Timbermate, works OK. Any suggestions? Any brands that work well? Mix your own?
Here's the joints. The gaps are small (and I have a little tear out in the plywood to deal with too. The magnification makes them look larger than life. Remember that the width of the border is 2.5"