Bruce Moffitt
Member
- Messages
- 34
- Location
- Ottawa, Ontario, Canada
I recently purchased a grizzly G0555X and added the riser kit. This is my first bandsaw and I'm not sure if I have the tension set properly.
I tried to follow the instructions in the manual.
"Release the tension one quarter of a turn at a time. Do this very slowly. When you see the bandsaw blade start to flutter, stop decreasing the tension. Now, slowly increase the tension until the blade stops fluttering, then tighten the tension one more quarter of a turn."
I must be doing something wrong (old eye's) because I can't see the blade fluttering.
Help!!!!!!!
I tried to follow the instructions in the manual.
"Release the tension one quarter of a turn at a time. Do this very slowly. When you see the bandsaw blade start to flutter, stop decreasing the tension. Now, slowly increase the tension until the blade stops fluttering, then tighten the tension one more quarter of a turn."
I must be doing something wrong (old eye's) because I can't see the blade fluttering.
Help!!!!!!!