Dan Mosley
Member
- Messages
- 1,169
- Location
- Palm Springs, Ca
looking for some suggestions on a motor i put on my old table saw
I have a 30amp breaker.......220outlet in the garage which my lathe and other tools work fine off of........i put this new motor on it and tried to wire it up 220.....but i think im doing something wrong.......The switch i used was the one on the table saw that a 3 phase motor was hooked up to....in the picture first wiring the table saw will start up and run great for about 30 sec and then trips the breaker.......in the pic labled second it got hot fast and a little smoke.....in the third it just hummmm and tripped the breaker......i used the wiring diagram on the motor to wire it but just cant get it right......any thoughts on how to wire this differently then i did (see pics) or suggestions on what im doing wrong ???? thanks Dan
I have a 30amp breaker.......220outlet in the garage which my lathe and other tools work fine off of........i put this new motor on it and tried to wire it up 220.....but i think im doing something wrong.......The switch i used was the one on the table saw that a 3 phase motor was hooked up to....in the picture first wiring the table saw will start up and run great for about 30 sec and then trips the breaker.......in the pic labled second it got hot fast and a little smoke.....in the third it just hummmm and tripped the breaker......i used the wiring diagram on the motor to wire it but just cant get it right......any thoughts on how to wire this differently then i did (see pics) or suggestions on what im doing wrong ???? thanks Dan
Attachments
Last edited: