Toni Ciuraneta
Member
- Messages
- 5,629
- Location
- Catalunya
Hi there.
I have to make four pieces like the one shown in #1 to make the four legs of a dresser I'm planning to make.
Hence I need to cut those stop cut corners at 45º angle, and I do not have a table saw.
I figured out a jig like in #2 would help me to make those cuts, I would make one cut on the right side of the saw and the other one on the left side.
However I have the doubt if the piece will not be supported enough to cut it safely.
Is there any other way to do it?
I've thought about inverting the jig so that the piece would point downwards but then I could only make the first cut and then I would need to stick a sheet of plywood that would give me the reference corner to slide on.
Any suggestion will be greatly appreciated.
Thanks
I have to make four pieces like the one shown in #1 to make the four legs of a dresser I'm planning to make.
Hence I need to cut those stop cut corners at 45º angle, and I do not have a table saw.
I figured out a jig like in #2 would help me to make those cuts, I would make one cut on the right side of the saw and the other one on the left side.
However I have the doubt if the piece will not be supported enough to cut it safely.
Is there any other way to do it?
I've thought about inverting the jig so that the piece would point downwards but then I could only make the first cut and then I would need to stick a sheet of plywood that would give me the reference corner to slide on.
Any suggestion will be greatly appreciated.
Thanks