Steven Pairo
Member
- Messages
- 3
I created a drawing of a desk clock in SU ver 6 and then used the scale tool to enlarge it based upon one of the dimensions, to a mantle sized clock and then saved it as a new file. I was experimenting with the cutlist plugin and used the mantle clock to try my first attempt at a cutlist. The list generated ok, I was able to read it, access it, no problem. However I noticed that the dimensions were not correct and upon further review I realized that the dimensions in the cutlist were the exact dimensions of the desk clock prior to it being scaled up.
Has anyone else experienced this, is there some procedure to avoid this?
SteveP.
Has anyone else experienced this, is there some procedure to avoid this?
SteveP.