Jason Tuinstra
Member
- Messages
- 122
- Location
- Hanford, CA
Here's a table I built after seeing something similar in a movie, hence I've dubbed it the "set" table. I had this wood laying around with nothing to do so I thought this might be a good project. I normally try and get rid of the sap wood but I didn't want to give up any width. I decided to use the bottom shelf to totally embrace sap wood and call attention to a piece I wouldn't normally use. A kind of if-you-can't-beat-it-join-it approach to sap wood I don't know if you like it, but I think it works. More importantly, so does my bride!
This was a ton of fun. I got a chance to do a ton of hand cut dovetails. I figured that because the table has a delecate look to it (thin legs, fine tapers), that I should make the pins as thin as possible. I don't think you can get the pins any thinner as they're the width of my fret saw blade.
I turned all the knobs - my first attempt at turning more than one knob. Only three additions to the scrap bin!
Right now I just have a coat of BLO on it. I wasn't planning on posing it until I had sprayed it, but the sun was out, it was 68F and the figure was popping. So there ya be. Thanks for looking!
Also, if you want to see the construction pics in all their gruesome detail, they're on my website. I'll try and get the Sketchup plans up there as well if your interested.
Thanks again!
This was a ton of fun. I got a chance to do a ton of hand cut dovetails. I figured that because the table has a delecate look to it (thin legs, fine tapers), that I should make the pins as thin as possible. I don't think you can get the pins any thinner as they're the width of my fret saw blade.
I turned all the knobs - my first attempt at turning more than one knob. Only three additions to the scrap bin!
Right now I just have a coat of BLO on it. I wasn't planning on posing it until I had sprayed it, but the sun was out, it was 68F and the figure was popping. So there ya be. Thanks for looking!
Also, if you want to see the construction pics in all their gruesome detail, they're on my website. I'll try and get the Sketchup plans up there as well if your interested.
Thanks again!
Attachments
-
SetTable.jpg124.9 KB · Views: 85
-
SetTable7.jpg138.8 KB · Views: 100
-
SetTable8.jpg137.3 KB · Views: 48
-
SetTable2.jpg124.2 KB · Views: 48
-
SetTable6.jpg123.5 KB · Views: 66
-
SetTable3.jpg128 KB · Views: 71
-
SetTable4.jpg122.8 KB · Views: 74
-
SetTable9.jpg106.3 KB · Views: 61
-
SetTable5.jpg130 KB · Views: 73
Last edited: