Gregory Hairston
Member
- Messages
- 67
I have an 8 inch Bridgewood Jointer that I purchased used a while ago. When I turn it on it starts up slow and takes about 20 seconds to get up to full speed. If I Face Joint a board and take more than a 1/32nd of a cut it bogs down. It is not the belt slipping. The motor actually slows and stops. Anyone have any ideas. Could the cord length to the outlet have anything to do with it? Do I need to replace the motor or is there anything else I can check out. I am going to sell this machine in the near future and I want it fully operational prior to selling.
Greg
Greg