Bartee Lamar
Member
- Messages
- 499
- Location
- Alpharetta GA ( Metro Atlanta)
I have been working on a Norm router table for months.
It has gone very well. Except for a few problems.
One problem is you should NEVER route with one hand on the router. I was really sad after all the work I put in the Last route on the table top slipped.
I think I can fill this in with Bond-do What do YOU Think ???
Here is the problem
Just so you can see the whole thing here is a picture of the whole top.
I have been accumulating parts for 3 years. The INCRA adjuster is an old product from Rockler that I bought from a classified in one the wood forums.
The fence is a Rockler Fence.
The Mitre bar track is from Peachtree Woodworking.
Well more later... my dinner is ready.
I am having so much fun with my new Canon A540.....
It has gone very well. Except for a few problems.
One problem is you should NEVER route with one hand on the router. I was really sad after all the work I put in the Last route on the table top slipped.
I think I can fill this in with Bond-do What do YOU Think ???
Here is the problem
Just so you can see the whole thing here is a picture of the whole top.
I have been accumulating parts for 3 years. The INCRA adjuster is an old product from Rockler that I bought from a classified in one the wood forums.
The fence is a Rockler Fence.
The Mitre bar track is from Peachtree Woodworking.
Well more later... my dinner is ready.
I am having so much fun with my new Canon A540.....